[sauld68]

I have a 98 Chrysler Concord, with the 2.7 engine. when starting the car fails to start on the first attempt. If I let the engine crank 3-4 seconds and then cycle the fuel pump a second time the car will start. When accelerating there appears to be a cutting out issue at time, mostly when accelerating harder than normal. The air bag light is on, the speedometer dose not display and the Tachometer will not read. I had the codes pulled and the following codes flashed. I replaced the cam sensor as well as the crank sensor. P0340 No cam signal at PCM P1687 No MIC BUS Message P1695 No CCD/J1850 Message from Body Control Module P1698 No CCD/J1850 Message from TCM

I have tested the Yellow/Violet wire at pin 59 and discovered no voltage.
Where should I go from here?